This is a well made component that does the job. However, I also used some L connectors in my 2-circuit track project and discovered that they can also be used to feed power (check out my reviews on them) and this would have greatly simplified my installation. However, if you need this I-connector it is a good part. My reason for only 4 out of 5 stars is that working with the screw terminals is a bit tricky. For each of the white, black, and red wire screws you have to fit both your power source wire and a horseshoe terminated track pass-through wire. It was a bit painful with my 12 gauge wire, probably less so with 14 gauge.
It would have been much nicer if the pass-through was terminated internally, leaving the screws just for power source. In addition, the ground screw is so close to the knockout hole that the cable connector retainer ring is right against it.
By:Mario D. , Homeowner (Ocean, NJ)
By:Pearl S. , Homeowner (Portland, OR, USA)
By:Jeff C. , Homeowner (Cheboygan ,MI)